used packard bell monitors

used packard bell monitors, 10
used packard bell monitors

Can I use another monitor brand on an old Packard Bell computer?

The Packard-Bell, who had stopped functioning properly and another monitor connected to the computer, but everything he says is that the Monitor "No Signal". I know the monitor works because it left a new computer and it worked before I move. My computer Packard Bell is a very old (purchased in '95). I also added more memory to computer chips could have something to do with the monitor does not work.

If the monitor has stopped working immediately after the last level of RAM, then yes, that indicate a problem with memory or install memory and not the monitor. I would also point out that you can use with any screen of any computer, you always have the right cable to connect the video output of your computer. Most instructors Does it use a 15-pin VGA connector, DVI is becoming more popular nowadays. Usually, if the RAM is installed incorrectly or if the memory is damaged or "bad", the computer beeps twice when you turn on and then do nothing afterwards. The video does not turn on and the monitor says "no signal" as you describe. The first thing to do is remove the memory you added and restore the computer to its previous state. Sometimes, it is important to ensure that the RAM (and new) of the age not only firmly anchored in place, but in the right slots. The order of the RAM is the primary card is relavent and depends on the make and model of the motherboard of your computer. Once you can get the computer to activate properly with the configuration of the original memory, try installing the new RAM again and make sure it is in the right slots and firmly in place. If the computer still does not light, you have either bad RAM or you have purchased the correct memory for your computer you have. Good luck.

used packard bell monitors, 35, “”, “”
used packard bell monitors, 10

Be Sociable, Share!

•